Assignment 1: Bootloader Jig (IN PROCESS)
The project consists of developing a shield for an Arduino UNO which makes bootloading brand new microcontrollers easily. In this specific case I will be flashing an ATTiny85 micrcontroller. To make this procedure I followed Andrew Sigler’s Programming an ATTiny85 Guide.
Bill of Materials
— 1 Arduino Uno
– 1 ATTiny85 microntroller
– 1 470 uF Capacitor
– 1 0.1 uF Capacitor
– 1 PCB Board of choice
– 1 LED
– 40 cms 22auw wire
Mainly, the process consists of flashing the code onto the ATTiny85 microcontroller using an Arduino Nano.
Now that I could see the LED blinking, it meant the code was uploaded!
After checking the whole circuit worked on the breadboard, I soldered the whole setup onto the PCB board.
Finally, after a bit of flux and a couple soldering, I made the Jig!
Thanks for reading!